Abstract
In electrical impedance tomography (EIT) currents are applied into a volume through electrodes and the resulting voltages at the electrodes are measured. The impedance distribution inside the volume can then be calculated by solving the associated inverse problem. Usually the equipment that is needed for the generation of the current patterns and the measurements are large, expensive and tailored to specific situations. In such cases many of the measurement parameters are fixed and the user cannot change these to adapt the equipment to another measurement situation. In this article we present a simple and affordable EIT measurement device that is based on a PC computer, commercial data acquisition board and software and an external current generation and switching board. We also verify the performance and applicability of the system with a phantom measurement and an unusual measurement object for which there is no specific equipment, that is, the measurement of internal impedance distribution of spruce logs.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.