Abstract

ABSTRACTIn this study, we analytically solved the problem of a functionally graded beam with different moduli in tension and compression under the action of uniformly distributed loads. By determining the location of the unknown neutral layer of the beam, we first established a simplified mechanical model based on complete partition of tension and compression. Using boundary conditions and continuity conditions of the neutral layer, we obtained an elasticity solution of the problem, in which grade functions of tensile and compressive moduli of elasticity are assumed to be two different exponential expressions while Poisson's ratio is unchanged. The numerical results and comparison also verified the validity of the analytical solution. By changing the grade parameters of the material, the stress and displacement of the beam in three cases, i.e., the tensile modulus is greater than, equal to, or less than the compressive modulus, are discussed, respectively. The result shows that due to the introduction of bimodular effect and functional grade of materials, the maximum tensile and compressive bending stresses may not take place at the bottom and top of the beam, which should be given more attention in the analysis and design of structures made of functionally graded materials with bimodular effect.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.