An efficient ultra-wideband digital transceiver for wireless applications on the field-programmable gate array platform

Abstract

<p>The ultra-wideband (UWB) technology is a promising short-range communication technology for most wireless applications. The UWB works at higher frequencies and is affected by interferences with the same frequency standards. This manuscript has designed an efficient and low-cost implementation of IEEE 802.15.4a-based UWB-digital transceiver (DTR). The design module contains UWB transmitter (TX), channel, and UWB-receiver (RX) units. Convolutional encoding and modulation units like burst position modulation and binary phase-shift keying modulation are used to construct the UWB-TX. The synchronization and Viterbi decoder units are used to recover the original data bits and are affected by noise in UWB-RX. The UWB-DTR is synthesized using Xilinx ISE<sup>®</sup> environment with Verilog hardware description language (HDL) and implemented on Artix-7 field-programmable gate array (FPGA). The UWB-DTR utilizes less than 2% (slices and look-up table/LUTs), operates at 268 MHz, and consumes 91 mW of total power on FPGA. The transceiver achieves a 6.86 Mbps data rate, which meets the IEEE 802.15.4a standard. The UWB-DTR module obtains the bit error rate (BER) of 2×10<sup>-4</sup> by transmitting 105 data bits. The UWB-DTR module is compared with similar physical layer (PHY) transceivers with improvements in chip area (slices), power, data rate, and BER. </p>