An Efficient Fluorescence Resonance Energy Transfer (FRET) between Pyrene and Perylene Assembled in a DNA Duplex and Its Potential for Discriminating Single‐Base Changes

Abstract

To increase the apparent Stokes' shift of perylene, pyrene (donor) and perylene (acceptor) were assembled in a DNA duplex to achieve the efficient fluorescence resonance energy transfer (FRET) from pyrene to perylene. Multiple donors were introduced in the vicinity of acceptors through D-threoninol and natural base pairs were inserted between the dyes. Accordingly, donors and acceptors could be accumulated inside the DNA without forming an undesired excimer/exciplex. When two pyrene moieties were located in proximity to one perylene with one base pair inserted between them, efficient FRET occurred within the duplex. Thus, strong emission at 460 nm was observed from perylene when excited at 345 nm at which pyrene has its absorption. The apparent Stokes' shift became as large as 115 nm with a high apparent FRET efficiency (Phi>1). However, the introduction of more than two pyrenes did not enhance the fluorescence intensity of perylene, due to the short Förster radius (R(0)) of the donor pyrene. Next, this FRET system was used to enlarge the Stokes' shift of the DNA probe, which can discriminate a one-base deletion mutant from wild type with a model system by incorporation of multiple donors into DNA. Two perylene moieties were tethered to the DNA on both sides of the intervening base, and two pyrenes were further inserted in the vicinity of the perylenes as an antenna. Hybridization of this FRET probe with a fully matched DNA allowed monomer emission of perylene when the pyrenes were excited. In contrast, excimer emission was generated by hybridization with a one-base deletion mutant. Thus, the apparent Stokes' shift was enhanced without loss of efficiency in the detection of the deletion mutant.