Abstract

This paper proposes an effective processing method for fabricating microchannels on the polycarbonate (PC) substrate with CO2 laser. The width of microchannel has close relationship with CO2 laser parameters including laser power, laser moving velocity, and length of microchannel. In order to optimize the width of the microchannel, the orthogonal experiment method is successfully applied in this experiment with L9(33) orthogonal test table. Then, the optimal machining parameters are obtained and a verified experiment is confirmed. Finally, the optimal microcahnnels on the PC can be obtained with the presented process parameters.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.