An Earlier Bar to Rescaling Units

Abstract

Solomon Golomb, in his letter to Physics Today ( Physics Today 0031-9228 54 10 2001 12 https://doi.org/10.1063/1.1420537. October 2001, page 12 ) has proposed that physical quantities—for example, time and temperature—be expressed in logarithmic scales, preferably based on the decibel system widely used by engineers. Years ago, the late Lewi Tonks and I made the same proposal, 1 1. G. C. Baldwin, L. Tonks, Nature 203, 633 (1964); https://doi.org/10.1038/203633a0 Bull. Am. Phys. Soc. 9, 476 (1964). but specifically for measures of pressure or vacuum. We proposed to use the common logarithm (base 10) of the absolute pressure in bars, and to name the unit step on that scale “one boyle.” We noted that “one deciboyle,” one-tenth of a boyle (about 12%), would be a fair measure of the precision with which extremely high or low pressures are measured in all but the most precise work. Our paper referred to similar earlier proposals and mentioned a table of constants to be added to 10 times the logarithm of pressures expressed in various units (for example, torr, inches of mercury, psi, and atmospheres) to convert them to the deciboyle scale. It also gave a list of examples ranging from the lower limits of the ionization gauge (−140 dB) to the pressure at Earth’s center (65.61 dB).Besides the Nature article, our proposal was presented to the American Society of Mechanical Engineers at their winter meeting in 1964 2 2. G. C. Baldwin, L. Tonks, American Society of Mechanical Engineers Pub. no. 64-WA/PT-19,d, United Engineering Center, New York (1964). and was described to and discussed by readers of the trade journal Research/Development. 3 3. G. C. Baldwin, L. Tonks, Research/Development, F. D. Thompson Publications, Inc., February 1965, and comments in the issues of September 1965 and March 1966. Predictably, there were various alternative proposals. When readers were polled by the journal, 43% favored “retaining the present system”—whatever that is!—while 41% favored some form of logarithmic scale. Not all of the 41%, however, favored our designation of the bar as the base of the scale. Many said that we already have a logarithmic system in the prefixes (milli, micro, and so forth). We responded to them at length in the March 1966 issue, noting “an irrational component of conservatism in such matters, which has been noted and deplored by most students of creativity.” 3 3. G. C. Baldwin, L. Tonks, Research/Development, F. D. Thompson Publications, Inc., February 1965, and comments in the issues of September 1965 and March 1966. To my knowledge, that was the first proposal to apply the decibel system to other than acoustic measurements, and the only one I have been aware of before Golomb’s letter. I am unaware of any formal action on our proposal.I wish Golomb more success with this proposal than we had 35 years ago!REFERENCESSection:ChooseTop of pageREFERENCES <<1. G. C. Baldwin, L. Tonks, Nature 203, 633 (1964); https://doi.org/10.1038/203633a0 , Google ScholarCrossref, ISI Bull. Am. Phys. Soc. 9, 476 (1964). , Google Scholar2. G. C. Baldwin, L. Tonks, American Society of Mechanical Engineers Pub. no. 64-WA/PT-19,d, United Engineering Center, New York (1964). Google Scholar3. G. C. Baldwin, L. Tonks, Research/Development, F. D. Thompson Publications, Inc., February 1965, and comments in the issues of September 1965 and March 1966. Google Scholar© 2002 American Institute of Physics.