Abstract
Traditionally the bit error rate characteristics (BER) was measured for a certain number of bit-energy-to-noise ratio, Eb/No. For each point a sample of r bits is used which depends on the expected BER value. The smaller BER value the bigger the sample r. Thus, to obtain the same accuracy at each point a method of errors and trials should be used. Therefore this method extends the time of measurement and measure BER values at all points with different accuracy. This paper presents a method which allows the automated and accurate measurement of the BER characteristics at a number of points with equal accuracy at each point by using the minimum sample size r. The method is tested by measuring BER characteristics of a FFSK modem.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
