Abstract
An automated system for measuring with five-hole pressure probes is described in this paper. This system was developed to deliver accurate results from a low speed linear cascade where competing geometries for aeroengines were tested. The total pressure differences between different geometries were small so an accurate measuring system was essential. The aim of this paper is to reduce the learning curve required to produce multi-hole pressure probe measurements. To this end the source codes to many of the programs used in the measuring system have been freely published for this paper.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
