Abstract
Numerical analysis of delamination failure in composite laminates is very often carried out with cohesive interface element in a finite element framework, due to their robustness and ease of use. Explicit time integration is often preferred, to overcome material and damage non-linearity and impact loading scenarios. However, a very fine mesh is needed to correctly represent the nonlinear cohesive zone ahead of the numerical crack tip to achieve a stable and mesh size insensitive global failure response. This is especially true for mode I delamination cases, where the cohesive zone is extremely small, owing to a low critical energy release rate. This mesh size requirement limits the applicability of cohesive zone models largely to coupon scale problems. The current work augments cohesive elements with additional rotational degrees of freedom at the nodes, which enables a higher order displacement approximation and allows relatively coarser mesh to be used. The present formulation is applied to a mode I delamination benchmark problem, which demonstrates the superiority of the augmented element over the traditional cohesive element in terms of coarse-mesh accuracy and computational time saving.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.