An approach for matrix densification based on particle packing and its effect on lightweight Al2O3-MgO castables

Abstract

For lightweight refractory containing lightweight aggregates, the properties of the matrix are decisive to its performance. In the present work, Dinger–Funk equation was adopted to calculate the theoretical packing density of a castables matrix based on Stovall linear packing model and to design its particle size distribution. Four lightweight Al2O3-MgO castables with different particle size distribution (represented by q-value) were prepared and examined. Results show that a suitable q-value was needed to ensure acceptable properties including sintering characteristics, strength and slag resistance, which deteriorated distinctly at high q (>=0.31). For the sample with q=0.28, the matrix showed dense and uniform mirostructure, and the properties of castable reached a favourable compromise among sintering characteristics (apparent porosity=14.8%, bulk density=3.02gcm−3, permanent linear change<0.6%), strength (cold modulus of rapture=12.4MPa, cold crashing strength=155.5MPa), and resistance against both slag corrosion (Ic=22.4%) and penetration (Ip=11.5%). The sample with q=0.25 showed the highest strength and resistance against slag corrosion (matrix dissolved in slag), but its slag penetration resistance was lower due to the existence of cracks between aggregates and matrix.