An Approach for 3D Modeling of the Regular Relief Surface Topography Formed by a Ball Burnishing Process Using 2D Images and Measured Profilograms.

Abstract

Advanced in the present paper is an innovative approach for three-dimensional modeling of the regular relief topography formed via a ball burnishing process. The proposed methodology involves capturing a greyscale image of and profile measuring the surface topography in two perpendicular directions using a stylus method. A specially developed algorithm further identifies the best match between the measured profile segment and a row or column from the captured topography image by carrying out a signal correlation assessment based on an appropriate similarity metric. To ensure accurate scaling, the image pixel grey levels are scaled with a factor calculated as being the larger ratio between the ultimate heights of the measured profilograms and the more perfectly matched image row/column. Nine different similarity metrics were tested to determine the best performing model. The developed approach was evaluated for eight distinct types of fully and partially regular reliefs, and the results reveal that the best-scaled 3D topography models are produced for the fully regular reliefs with much greater heights. Following a thorough analysis of the results obtained, at the end of the paper, we draw some conclusions and discuss potential future work.