Abstract
A new ultrasonic method of viscosity measurements at a high-pressure conditions has been presented. The method is based on the Love wave amplitude measurement. The same electronic setup as in the Bleustein–Gulyaev (B–G) wave method applied by the authors recently for a high-pressure measurement was adopted. The new sensors were made of metallic materials, which make them more reliable at high-pressure conditions. The method has been successfully applied for the viscosity measurement of some triglycerides at high-pressure conditions up to 1 GPa. The results have been compared with the earlier results obtained using B–G waves. This comparison has shown that Love wave method sensors are more reliable than B–G wave sensors and are also cheaper in fabrication, although the sensitivity of Love wave sensors is lower. During the measurement, the phase transitions in the investigated liquids were observed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.