An analytical approach to symmetry breaking in multipole RF-traps

Abstract

Radio-frequency (RF) linear multipole traps have been shown to be very sensitive to mis-positioning of their electrodes, which results in a symmetry breaking and leads to extra local minima in the trapping potential as shown in Pedregosa-Gutierrez et al (2018 J. Mod. Opt. 65 529) disturbing the operation of the trap. In this work, we analytically describe the RF-potential of a realistic octupole trap by including lower order terms to the well-established equation for a perfectly symmetric octupole trap. We describe the geometry by a combination of identified defects, characterized by simple analytical expressions. A complete equation is proposed for a trap with any electrode deviation relying on a combination of the simple cases where the defects are taken individually. Our approach is validated by comparison between analytical and numerical results for defect sizes up to 4% of the trap radius. As described in Pedregosa-Gutierrez et al (2018 Rev. Sci. Instrum. 89 123101), an independent fine-tuning of the amplitude of the RF voltage applied on each electrode can be used to mitigate the geometrical defects of a realistic trap. In a different way than in Pedregosa-Gutierrez et al (2018 Rev. Sci. Instrum. 89 123101), the knowledge of an analytical equation for the potential allows to design the set of RF-voltages required for this compensation, based on the experimental measurement of the ion positions in the trap, without information concerning the exact position of each electrode, and with a small number of iterations. The requirements, performances and limitations of this protocol are discussed via comparison of numerical simulations and analytical results.