Abstract
This paper describes an experimental investigation on hard turning of disc type automotive gears made of 20Mn5Cr5 steel hardened to 60±2 HRC against grinding process. Experiments are conducted by using PCBN tools on a CNC turning centre without using coolant. The effect of machining parameters; cutting speed (vc), feed rate (f) and depth of cut (ap) on the surface roughness Ra (µm) is analyzed and optimized with the help of Taguchi design of experiment (DOE), signal to noise (S/N) ratio and analysis of variance (ANOVA) methods. The surface quality, process characteristics, some economical and ecological features of the hard turning are analyzed and compared with the grinding.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
