Abstract

In this paper, an all-Si resonant pressure microsensor based on eutectic bonding was developed, which can eliminate thermal expansion coefficient mismatches and residual thermal stresses during the bonding process. More specifically, the resonant pressure microsensor included an SOI wafer with a pressure-sensitive film embedded with resonators, which was eutectically bonded with a silicon cap for vacuum encapsulation. The all-Si resonant pressure microsensor was carefully designed and simulated numerically, where the use of the silicon cap was shown to effectively address temperature disturbances of the microsensor. The microsensor was then fabricated based on MEMS processes where eutectic bonding was adopted to link the SOI wafer and the silicon cap. The characterization results showed that the temperature disturbances of the resonant pressure microsensor encapsulated with the silicon cap were quantified as -0.82 Hz/°C of the central resonator and -2.36 Hz/°C of the side resonator within a temperature range from -40 °C to 80 °C, which were at least eight times lower than that of the microsensor encapsulated with the glass cap. Compared with the microsensor using the glass cap, the all-silicon microsensor demonstrated an accuracy improvement from 0.03% FS to 0.01% FS and a reduction in short-term frequency fluctuations from 3.2 Hz to 1.5 Hz.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.