Abstract
Until recently, no analytical technique was available for the study of failure in complex sheet metal pressing. However, if the maximum ( e1) and minimum ( e2) principal surface strains at failure on sheet metal pressing are measured, a plot of e1 against e2 results in a so-called forming limit diagram. FLD can be constructed in the laboratory and used as an aid to die try-out, production failures and metal specification.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
