Abstract
A new technique which uses the output of a true RMS voltmeter to measure the acoustic emission energy output of a transducer is presented. To demonstrate its use in a typical case, this procedure is used to measure acoustic emission energy during tensile tests on [0°/±30°/90°]s glass-epoxy laminate uniaxial and 10° off-axis tensile coupons. The test results were compared with numerical predictions of laminate response and acoustic emission energy. The experiments indicate that acoustic emission energy can be used to indicate the onset of ply and interlaminar failure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.