Abstract
This work details the fabrication and performance of a sensor for ammonia gas, based on conducting polymer. The fabrication procedure consists following steps; polyaniline synthesis via oxidative polymerization technique, then a sensitive polyaniline film was deposited on a printed circuit board and finally, polyaniline microdevice were assembled on an interdigitated electrode arrays to fabricate the sensor for amomonia gas detection. Response time of this chemiresistive devices and humidity impact were examined for NH3 sensitivity and compared with commercial gas sensors (Taguchi Model 826). Data export from sensor to the computer was carried out via data logger model ADC-24 and analyzed using SPSS software. The sensor was found to have a rapid (t = 40 s) and stable linear response to ammonia gas in the concentration range of interest (50–150 ppm) under room temperature operation condition. It was reviled also reliable results to the variation of environment humidity. Power consumption, sensitivity, dimension, flexibility and fabrication cost were used as most important parameters to compare the new polymer based device with those of other similar works and the results showed that small size, low cost, flexibility, low power consumption and high sensitivity are from the benefits of this innovative device. In real-time application conditions flexible polyaniline based gas sensor with polyimide substrate in thickness 0.25 mm exhibits relatively good performance and accurate evaluation of food spoilage.
Paper version not known (
Free)
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Materials Science: Materials in Electronics
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
