Aluminum and Molybdenum Co-Doped Zinc Oxide Films as Dual-Functional Carrier-Selective Contact for Silicon Solar Cells.

Abstract

Aluminum-doped zinc oxide (AZO) is considered as a promising candidate as transparent conductive oxide (TCO) for silicon heterojunction solar cells due to its high carrier density, nontoxic nature, and low cost. Herein, it is presented that the transparency of the AZO film can be optimized through co-sputtering of AZO and molybdenum oxide (MoOx). Furthermore, aluminum and molybdenum co-doped zinc oxide (MAZO) can be used as both the TCO layer and electron-selective contact (ESC) for silicon heterojunction solar cells. The surface morphology, cation oxidation state, and optical and electrical properties of all MAZO films are characterized. It is found that the transmittance of all MAZO films is significantly increased at a wavelength of 450-800 nm due to MAZO with a stronger Zn-O bond and a wider band gap. The conductivity of MAZO films is approximate to AZO films at a low MoOx target deposit power (50 W), and the sheet resistance of MAZO films increases significantly by increasing the deposition power up to 100 W. Finally, the optimized MAZO films are used as TCO and ESC for silicon heterojunction solar cells, showing a power conversion efficiency of 19.58%. The results show an effective stage to improve the optical properties of AZO through co-doping and the possibility of applying MAZO as a dual-functional layer for silicon solar cells.