Abstract
Different mole ratio Al-B catalysts (Al-10B to Al-35B) were synthesized by using sol-gel (SG) method. Ethyl benzene (EB) dehydrogenation in the presence of oxygen and water steam was carried out on these catalysts at 450–500 °C with EB contact time of 0.54 gcat.s.cm–3. Acidity of Al-B catalysts was estimated by using NH3-TPD-mass spectral analysis studies. SEM-mapping images revealed fine distribution of boron up to 15% of its loading in alumina (Al-15B), whereas, boron aggregation was observed in higher boron content (Al-25B and Al-35B) catalysts. Essentially, acid sites of very weak strength (Tmax ≤ 125 °C) were observed for Al and Al-10B catalysts and resulted in low EB conversion and styrene yield. On the other hand, acid sites of weak strength (Tmax ≤ 180 °C) were observed for Al-25B and Al-35B catalysts and resulted in high EB conversion. However, greater styrene yield (43.2%) with reasonable EB conversion (46%) was obtained on acid sites of weak moderate strength in Al-15B catalyst. Further, Al-15B catalyst was synthesized by using co-precipitation (COP) and impregnation (IMP) methods. Acid sites related to NOx formation during the NH3-TPD-mass analysis on IMP and COP catalyst essentially improved the EB conversion to 66% and 63% respectively at 500 °C. However, these acid sites were diminished in Al-B SG catalyst and resulted in 50% of EB conversion at 500 °C. At 50% of EB conversion level, styrene selectivity of 73%, 82.5% and 84% were observed on Al-B IMP, Al-B COP and Al-SG catalysts, respectively. Hence, different method of preparation of Al-B catalyst generated acid sites of different strength and density and thereby influenced the styrene formation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.