Alumina/Silicon Carbide Laminated Composites by Spark Plasma Sintering

Abstract

Ceramic laminates composed of alumina/silicon carbide composite layers were produced by spark plasma sintering (SPS). Monolithic composite disks containing up to 30 vol% of silicon carbide were fabricated by stacking together and cosintering by SPS green layers prepared by tape casting water‐based suspensions. An engineered laminate with a specific layer combination that is able to promote the stable growth of surface defects before final failure was also designed and produced. Fully dense materials with an optimum adhesion between the constituting layers and a homogeneous distribution of the two phases were obtained after SPS. Monolithic composites showed an increasing strength with SiC load, and biaxial strength values as high as 700 MPa were observed for a SiC content of 30 vol%. The engineered laminate showed a peculiar crack propagation that is responsible for the high strength value of about 600 MPa and for the evident insensitivity to surface defects.