Al-Ti-C (CNTs) master alloys improve room temperature and high-temperature mechanical properties of ZL205A alloy

Abstract

The insufficient high-temperature properties of Al-Cu alloys represent a significant obstacle to their further development. The use of master alloy refiners can enhance the mechanical properties while refining the grains. This paper describes the preparation and characterization of Al-Ti-C (CNTs) master alloys containing submicron TiC particles through the aluminum melt reaction method, utilizing graphite powders (GPs) and (CNTs) as carbon sources,respectively.The effects of these two types of intermediate alloys on the microstructures and high-temperature mechanical properties of the ZL205A alloy were investigated at varying additive amounts. The results indicate that the Al-Ti-C (CNTs) master alloys contain TiC particles measuring up to 183 nm and 480 nm, respectively, with the Al-Ti-CNTs demonstrating a superior effect on the refinement of the ZL205A alloy. The optimal mechanical properties were achieved upon the addition of 0.3 wt% of the master alloy to the ZL205A alloy. The mechanical properties improved from 341.53 MPa (yield strength), 371.68 MPa (tensile strength), and 3.3 % elongation without the addition of master alloys to 413.20 MPa, 471.82 MPa, and 11.2 % with the addition of Al-Ti-CNTs and to 440.85 MPa, 492.61 MPa, and 10.8 % with the addition of Al-Ti-C, respectively.At a high temperature of 300°C, the mechanical properties of the ZL205A alloy improved from 144.0 MPa and 10.8 % (Al-Ti-C) to 174.87 MPa and 11.2 %, and 195.1 MPa and 13.8 % (Al-Ti-CNTs). The TiC particles generated in situ under a different carbon sources demonstrated distinct mechanisms in the grain refinement of the ZL205A alloy. TiC (GPa) with a larger size primarily impeded the further growth of grains, while TiC (CNTs) promoted the formation of crystalline nuclei and heterogeneous nucleation sites, thereby achieving grain refinement. Large-sized TiC particles prepared using graphite as the carbon source hindered further grain growth, whereas TiC produced using carbon nanotubes promoted the formation of nuclei and heterogeneous nucleation sites, resulting in grain refinement. In addition, both types of TiC particles contribute to the densification and strengthening of the ZL205A alloy through fine grain strengthening, precipitation strengthening, Orowan strengthening, load transfer strengthening, the pinning effect, and thermal mismatch strengthening. However,TiC(CNTs) exhibits a greater contribution to strength due to its high quantity and small size.