Abstract
AbstractFor seismic ahead‐of‐the‐face prediction in tunnelling, sources with known properties are usually used, which, however, are not compatible with NATM. In order to integrate geophysical exploration into conventional tunnelling, the feasibility of construction machinery for generating seismic source signals was investigated. Passive monitoring during conventional tunnelling was used to analyse the seismic signals. Different radiation characteristics of drilling, blasting and bouldering could be identified and their characteristics regarding range and spectrum of the signal could be determined. In subsequent system tests, various machines used in NATM tunnelling were examined for their suitability as sources. The sensor positioning for source signal pickup was evaluated by stroke tests and during ongoing tunnelling operations. For the registration of the waves in the rock mass, different receivers with different geometries were used to characterize the wave field emitted to the front or side of the sources. In addition, the necessary processing steps were determined in order to make these signals usable for an ahead‐of‐the‐face exploration. The results and data form a basis for further development into a practical technical solution for conventional tunnel construction.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.