Abstract
This paper investigates the feasibility of using commercially available loudspeakers as low-cost linear alternators for thermoacoustic applications, to convert acoustic power to electricity. The design of a purpose built experimental apparatus, in which a high intensity acoustic wave is induced by using a high power woofer, is described. The rig is used to excite loudspeakers (referred here as “alternators”) under test, while a pair of microphones and a laser displacement sensor are used to enable acoustic power measurements. The paper presents a case study in which characteristics of acoustic-to-electric energy conversion of a candidate loudspeaker (alternator) – selected from the viewpoint of general performance, as well as parameters such as: high force factor, low electrical resistance and low mechanical loss – are measured. The measurements of acoustic power absorbed by the alternator and the electric power extracted from it by the load resistor, which allow estimating acoustic-to-electric efficiencies, are presented. The alternator has been tested at different operating frequencies, cone displacements and load resistance values. The measurement results are discussed and compared in detail with the calculations based on the linear acoustics model.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.