Al(Si)/Al2O3 and NiAl(Si)/Al2O3 co-continuous composites obtained by low temperature reactive metal penetration of dense silica preforms

Abstract

Listen

Translate article

Interpenetrating network Al(Si)/Al2O3 composites, obtained by a reactive metal penetration process, where pure aluminum metal reacts with a dense amorphous silica preform, are an interesting class of metal/ceramic composites, with two continuous networks of metal (Al-Si alloy) and ceramic (Al2O3). These composites have high stiffness and hardness, while retaining acceptable toughness and good thermal and electrical conductivity, and can be used in wear or thermal management applications. A second infiltration step with nickel allows to substitute the Al(Si) alloy with an intermetallic, obtaining an interpenetrating network NiAl(Si)/Al2O3 composite, with very high hardness and melting point. While in the standard process the temperature for obtaining the Al(Si)/Al2O3 composites is in the 1100–1200 °C range, in this paper we studied instead the 700–1000 °C temperature range and its effect on the microstructure of the final NiAl(Si)/Al2O3 composite. After the first infiltration step, the microstructure of Al(Si)/Al2O3 composites depends on both temperature and time of the treatment. At 700–800 °C and for reaction time of 1–2 h, the grain size is completely sub-micrometric. When temperature and time of reaction increase, islands with a coarser microstructure, of micrometric size, form, reaching a fully micrometric coarser microstructure at 1100–1200 °C. The islands formation is due to the transformation from transition aluminas, formed at low temperature and low reaction time, to α-alumina, while at high temperature α-alumina forms directly. In a second step, the Al(Si) metal network was replaced with an intermetallic one, by contacting the composite with liquid nickel, that reacted with the Al(Si) alloy forming an Al-Ni-Si intermetallic. The temperature and duration of the first infiltration step strongly influences not only the microstructure of the Al(Si)/Al2O3 composite but also of the final NiAl(Si)/Al2O3 one, that is finer when the first step (reaction of aluminum with silica) occurs at lower temperature.