Abstract
In order to obtain new resonance modes for frequency selection of the metasurface, one or two slits were introduced into the all-dielectric resonance unit, all-dielectric frequency selective metasurface based on this type resonance unit was designed by using the local characteristics of electromagnetic field by slit. After simulating its transmission characteristics, it was found that when the long side of the slit and the direction of the incident electric field were the same, a stop band could appear at the low frequency, and the electromagnetic field was mainly distributed between the resonance units. When the long side of the slit was perpendicular to the direction of the incident electric field, a stopband and a passband could appear at the high frequency. Meanwhile, with the increase of the resonance frequency,the local characteristics of the electromagnetic field were more obvious and were better limited within the slit. By adjusting the width, number and spacing of slits, the operating frequency of the metasurface could be adjusted in a large frequency range. At the same time, the relative position of the slit and incident electric field could be changed by rotation to realize the reconfiguration of the metasurface. These theoretical results provide important theoretical guidance for the design of more complex resonant units based on slit.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.