Alignment and characterization of remote-refocusing systems.

Abstract

The technique of remote refocusing is used in optical microscopy to provide rapid axial scanning without mechanically perturbing the sample and in techniques such as oblique plane microscopy that build on remote refocusing to image a tilted plane within the sample. The magnification between the pupils of the primary (O1) and secondary (O2) microscope objectives of the remote-refocusing system has been shown previously by Mohanan and Corbett [J. Microsc.288, 95 (2022)JMICAR0022-272010.1111/jmi.12991] to be crucial in obtaining the broadest possible remote-refocusing range. In this work, we performed an initial alignment of a remote-refocusing system and then studied the effect of axial misalignments of O1 and O2, axial misalignment of the primary tube lens (TL1) relative to the secondary tube lens (TL2), lateral misalignments of TL2, and changes in the focal length of TL2. For each instance of the setup, we measured the mean point spread function F W H M xy of 100nm fluorescent beads and the normalized bead integrated fluorescence signal, and we calculated the axial and lateral distortion of the system; all of these quantities were mapped over the remote-refocusing range and as a function of lateral image position. This allowed us to estimate the volume over which diffraction-limited performance is achieved and how this changes with the alignment of the system.