Abstract

The Chinese Ka-band solid-state transmitter cloud radar (CR) can operate in three different work modes with different pulse widths and coherent integration and non-coherent integration numbers to meet the requirement for long-term cloud measurements. The CR was used to observe cloud and precipitation data in southern China in 2016. In order to resolve the data quality problems caused by coherent integration and pulse compression, which are used to detect weak cloud in the cloud radar, this study focuses on analyzing the consistencies of reflectivity spectra using the three modes and the influence of coherent integration and pulse compression, developing an algorithm for Doppler spectral density data quality control (QC) and merging based on multiple-mode observation data. After dealiasing Doppler velocity and artefact removal, the three types of Doppler spectral density data were merged. Then, Doppler moments such as reflectivity, radial velocity, and spectral width were recalculated from the merged reflectivity spectra. Performance of the merging algorithm was evaluated. Three conclusions were drawn. Firstly, four rounds of coherent integration with a pulse repetition frequency (PRF) of 8333 Hz underestimated the reflectivity spectra for Doppler velocities exceeding 2 m·s−1, causing a large negative bias in the reflectivity and radial velocity when large drops were present. In contrast, two rounds of coherent integration affected the reflectivity spectra to a lesser extent. The reflectivity spectra were underestimated for low signal-to-noise ratios in the low-sensitivity mode. Secondly, pulse compression improved the radar sensitivity and air vertical speed observation, whereas the precipitation mode and coherent integration led to an underestimation of the number concentration of big raindrops and an overestimation of the number concentration of small drops. Thirdly, a comparison of the individual spectra with the merged reflectivity spectra showed that the Doppler moments filled in the gaps in the individual spectra during weak cloud periods, reduced the effects of coherent integration and pulse compression in liquid precipitation, mitigated the aliasing of Doppler velocity, and removed the artefacts, yielding a comprehensive and accurate depiction of most of the clouds and precipitation in the vertical column above the radar. The recalculated moments of the Doppler spectra had better quality than those merged from raw data.

Highlights

  • Ka- or W-band millimeter-wave cloud radars use transmitters that contain magnetrons, traveling wave tubes, and solid-state transmitters

  • A Ka-band cloud radar, the millimeter-wave cloud radar (MMCR) of the Atmospheric Radiation Measurement (ARM) Program sponsored by the United States (US) Department of Energy (DOE), uses traveling wave tubes and operates in four different modes that are cycled repetitively

  • The stratiform precipitation observed by the cloud radar on 4 June 2016 in southern China was used to analyze the consistencies of Doppler spectra, reflectivity, velocity, and spectrum width observed by the three work models

Read more

Summary

Introduction

Ka- or W-band millimeter-wave cloud radars use transmitters that contain magnetrons, traveling wave tubes, and solid-state transmitters. Second-trip echoes, and pulse compression sidelobes were considered in this algorithm Based on this algorithm, they analyzed the consistency of radar reflectivity measured in different modes. For a received radar signal, the fast Fourier transform (FFT) or other spectrum analysis algorithms can be utilized to obtain the cloud radar Doppler spectra, which contain a wealth of information about cloud properties, vertical air motion, and turbulence [4]. In these works, the MMCR radar recorded three moments of the Doppler spectra (reflectivity, velocity, and spectral width) and discarded the Doppler spectra. The peak power was high enough to not use the pulse compression technique and coherent integration

Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call