Alginate-gelatin emulsion droplets for encapsulation of vitamin A by 3D printed microfluidics

Abstract

Microfluidics is characterized by the manipulation of fluids in submillimeter channels and has great application potential in encapsulation. To further extend the application of microfluidics in food industries, a 3D printed microfluidic device is used to encapsulate vitamin A and improve its stability. Two natural macromolecules, sodium alginate and gelatin, are added to water as the continuous phase to generate monodisperse emulsion. Under different flow rate ratios, the diameter of droplets decreases with the increase of continuous flow rate. However, at the same flow rate ratio, varying the dispersed and continuous flow rates does not significantly change the diameter and size distribution of emulsion collected. The prepared O/W (oil/water) single emulsion can form microgel particles and avoid degradation of vitamin A by simulated gastric acid; the encapsulated vitamin A will not be released until particles reach simulated intestinal tract. In the simulated digestion in vitro, no vitamin A is released for 2 h in the acidic environment; under an alkaline or neutral environment such as those in intestinal fluids, vitamin A can be released from the microgel particles within 2.5 h. Using the presented approach, emulsions encapsulating vitamin A have been prepared and can potentially be applied to encapsulate other oil-soluble substances in the food industry.