Abstract
Ethanol is determined by a sensor system using purified, immobilized mernbrane-bound alcohol dehydrogenase frorn Gluconobacter suboxydans, attached to a platinum disk electrode (3 mm diameter), and covered with a dialysis membrane. Hexacyanoferrate (III) is used as the redox acceptor. To correct for the influence of interfering substances, this alcohol sensor is compensated by a control electrode which has no immobilized enzyme. The potential of these platinum electrodes was set at + 350 mV vs. Ag/AgCl. Linearity was observed in the range 0.1–5 mM ethanol, the response time was less than 5 min, the maximum sensitivity was obtained at 45°C and the optimum pH was in the range 4.5–5.5. The sensitivity decreased to 80% of the initial value after 1 month at 30°C. When the alcohol sensor system was applied to the determination of ethanol in alcoholic beverages, a good correlation was obtained between the results and those obtained by gas chromatography.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
