Abstract

ABSTRACT 6061 Al alloy and commercial steel were joined via the metal inert gas welding (MIG) with auxiliary high-frequency heating. The influence of parameters on the weld appearance and intermetallic compound layer was studied. The results showed that the increase of the high-frequency current voltage and MIG voltage made the intermetallic compounds layer thicken. The appearance of the weld was improved first and then deteriorated when the high-frequency electric voltage was raised. Interfacial tensile strength was relatively high when the interfacial compounds layer was 1 μm to 5 μm thick. Fracture analysis showed that the brittle fracture of the interfacial compound layer was the key factor that affected the joint tensile strength. Optimal process window was suggested: the heat input range of the high-frequency current was 720–810 J/cm, and that of MIG was 575–615 J/cm. The optimal joint presented more than 70% tensile strength of the 6061 Al.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.