Airborne PCB as a contamination risk on freeze-drying of sediment

Abstract

In a study of polychlorinated biphenyls (PCB) in freeze-dried sediments from Swedish lakes, the samples were found to contain unexpectedly high concentrations of PCBs. In one of the lakes (Björken), e.g. the concentration of PCB-28 was found to be 189 ng/g dw after freeze-drying compared to 7 ng/g dw after air-drying of the sediment and therefore our hypothesis was that the contamination had occurred during the freeze-drying procedure. Hence, a dry reference sediment (RS) was used in order to identify potential sources of PCB contamination. The investigation included freeze-drying of the dry RS in five different laboratories, exposure to the air in the freeze-drying room, storage at room temperature and air-drying in a certain fume hood and in a laminar flow clean bench. The pattern and concentrations of PCBs detected in the exposed RS were strongly influenced by low chlorinated PCB congeners under all of these conditions with exception for air-drying in the fume hood. Storage in the laboratory air resulted in a slight elevation in the concentrations of low chlorinated PCB congeners, whereas higher concentrations of all PCB congeners were observed after freeze-drying. In all experiments the contamination appeared to be due to adsorption of PCB from the laboratory air. On the basis of these findings we recommend that reference material be subjected to the entire procedure, including sample preparation, in order to monitor contamination and that a procedure involving solvent extraction of wet sediment samples is used, whenever possible, instead of procedures involving dry samples.