Abstract
Air-to-air membrane enthalpy exchanger is one of the environmentally friendly technologies that has been increasingly used in the building sector to recover the waste energy due to ventilation. In this study, we report the development of a facile approach for the deposition of a thin layer of the metal-organic frameworks (MOFs) ZIF-8 and HKUST-1 on polyvinylidene fluoride (PVDF) membranes in order to improve their water vapour transport properties. Material characterisation and properties determination were carried out for the tested membranes. It was shown that the surface hydrophilicity of the coated membranes was improved as compared to the pristine membrane. In general, the water vapour diffused through the coated membranes was higher than the pristine membrane at all the test conditions, while insignificant differences in the mechanical properties between the pristine membrane and the coated membranes were observed. The performance of the coated membranes in an air-to-air membrane enthalpy exchanger was then experimentally assessed. It was found that the effectiveness improved from 44.4% for pristine PVDF45 to 45.9% and 47.7% for the ZIF-8@PVDF45 and HKUST-1@PVDF45 membranes, respectively, at the flow rate of 0.24 L/s. This study provides a useful and facile method to enhance the performance of polymeric membranes used in air-to-air membrane enthalpy exchangers, which could potentially reduce both building energy consumption and greenhouse gas emissions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.