Air sampling and determination of vapours and aerosols of bitumen and polycyclic aromatic hydrocarbons in the Human Bitumen Study

Abstract

The chemical complexity of emissions from bitumen applications is a challenge in the assessment of exposure. Personal sampling of vapours and aerosols of bitumen was organized in 320 bitumen-exposed workers and 69 non-exposed construction workers during 2001-2008. Area sampling was conducted at 44 construction sites. Area and personal sampling of vapours and aerosols of bitumen showed similar concentrations between 5 and 10 mg/m(3), while area sampling yielded higher concentrations above the former occupational exposure limit (OEL) of 10 mg/m(3). The median concentration of personal bitumen exposure was 3.46 mg/m(3) (inter-quartile range 1.80-5.90 mg/m(3)). Only few workers were exposed above the former OEL. The specificity of the method measuring C-H stretch vibration is limited. This accounts for a median background level of 0.20 mg/m³ in non-exposed workers which is likely due to ubiquitous aliphatic hydrocarbons. Further, area measurements of polycyclic aromatic hydrocarbons (PAHs) were taken at 25 construction sites. U.S. EPA PAHs were determined with GC/MS, with the result of a median concentration of 2.47 μg/m(3) at 15 mastic asphalt worksites associated with vapours and aerosols of bitumen, with a Spearman correlation coefficient of 0.45 (95% CI -0.13 to 0.78). PAH exposure at mastic-asphalt works was higher than at reference worksites (median 0.21 μg/m(3)), but about one order of magnitude lower compared to coke-oven works. For a comparison of concentrations of vapours and aerosols of bitumen and PAHs in asphalt works, differences in sampling and analytical methods must to be taken into account.