Abstract
Air bubble size distribution in a laboratory flotation cell was investigated by using of image analysis technology in this paper. Results showed that it was feasible to determine the air bubble size according to image analysis software. For a porous media-aerated flotation cell, bubble size was dependent on poles size of porous media. Furthermore, operating parameters of the cell could affect the size. Mean bubble diameters increased with increasing of air flow rate. In contrast, it decreased when adding deinking agent. Its decreasing with increasing pulp flow rate under given conditions illustrated the fact that proper turbulence strength at the inlet of air bubbles was favorable for reducing bubble size. Gas holdup increased with increasing air flow rate to some extent, but it had a peak value. Gas holdup would rise obviously when deinking agent existed. An efficient approach to enhancing bubble surface area flux was to increase air flow rate and keep small bubble size at the same time.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
