Aggregation and Allocation of Greenhouse Gas Emissions in Oil and Gas Production: Implications for Life-Cycle Greenhouse Gas Burdens

Aluminum production is a major energy consumer and important source of greenhouse gas (GHG) emissions globally. Estimation of the energy consumption and GHG emissions caused by aluminum production in China has attracted widespread attention because China produces more than half of the global aluminum. This paper conducted life cycle (LC) energy consumption and GHG emissions analysis of primary and recycled aluminum in China for the year 2020, considering the provincial differences on both the scale of self-generated electricity consumed in primary aluminum production and the generation source of grid electricity. Potentials for energy saving and GHG emissions reductions were also investigated. The results indicate that there are 157,207 MJ of primary fossil energy (PE) consumption and 15,947 kg CO2-eq of GHG emissions per ton of primary aluminum ingot production in China, with the LC GHG emissions as high as 1.5–3.5 times that of developed economies. The LC PE consumption and GHG emissions of recycled aluminum are very low, only 7.5% and 5.3% that of primary aluminum, respectively. Provincial-level results indicate that the LC PE and GHG emissions intensities of primary aluminum in the main production areas are generally higher while those of recycled aluminum are lower in the main production areas. LC PE consumption and GHG emissions can be significantly reduced by decreasing electricity consumption, self-generated electricity management, low-carbon grid electricity development, and industrial relocation. Based on this study, policy suggestions for China’s aluminum industry are proposed. Recycled aluminum industry development, restriction of self-generated electricity, low-carbon electricity utilization, and industrial relocation should be promoted as they are highly helpful for reducing the LC PE consumption and GHG emissions of the aluminum industry. In addition, it is recommended that the central government considers the differences among provinces when designing and implementing policies.

Reducing life cycle greenhouse gas emissions of corn ethanol by integrating biomass to produce heat and power at ethanol plants

BackgroundThe availability of feedstock options is a key to meeting the volumetric requirement of 136.3 billion liters of renewable fuels per year beginning in 2022, as required in the US 2007 Energy Independence and Security Act. Life-cycle greenhouse gas (GHG) emissions of sorghum-based ethanol need to be assessed for sorghum to play a role in meeting that requirement.ResultsMultiple sorghum-based ethanol production pathways show diverse well-to-wheels (WTW) energy use and GHG emissions due to differences in energy use and fertilizer use intensity associated with sorghum growth and differences in the ethanol conversion processes. All sorghum-based ethanol pathways can achieve significant fossil energy savings. Relative to GHG emissions from conventional gasoline, grain sorghum-based ethanol can reduce WTW GHG emissions by 35% or 23%, respectively, when wet or dried distillers grains with solubles (DGS) is the co-product and fossil natural gas (FNG) is consumed as the process fuel. The reduction increased to 56% or 55%, respectively, for wet or dried DGS co-production when renewable natural gas (RNG) from anaerobic digestion of animal waste is used as the process fuel. These results do not include land-use change (LUC) GHG emissions, which we take as negligible. If LUC GHG emissions for grain sorghum ethanol as estimated by the US Environmental Protection Agency (EPA) are included (26 g CO2e/MJ), these reductions when wet DGS is co-produced decrease to 7% or 29% when FNG or RNG is used as the process fuel. Sweet sorghum-based ethanol can reduce GHG emissions by 71% or 72% without or with use of co-produced vinasse as farm fertilizer, respectively, in ethanol plants using only sugar juice to produce ethanol. If both sugar and cellulosic bagasse were used in the future for ethanol production, an ethanol plant with a combined heat and power (CHP) system that supplies all process energy can achieve a GHG emission reduction of 70% or 72%, respectively, without or with vinasse fertigation. Forage sorghum-based ethanol can achieve a 49% WTW GHG emission reduction when ethanol plants meet process energy demands with CHP. In the case of forage sorghum and an integrated sweet sorghum pathway, the use of a portion of feedstock to fuel CHP systems significantly reduces fossil fuel consumption and GHG emissions.ConclusionsThis study provides new insight into life-cycle energy use and GHG emissions of multiple sorghum-based ethanol production pathways in the US. Our results show that adding sorghum feedstocks to the existing options for ethanol production could help in meeting the requirements for volumes of renewable, advanced and cellulosic bioethanol production in the US required by the EPA’s Renewable Fuel Standard program.

Life cycle greenhouse gas emissions and freshwater consumption of liquefied Marcellus shale gas used for international power generation

Impacts of alternative fuel combustion in cement manufacturing: Life cycle greenhouse gas, biogenic carbon, and criteria air contaminant emissions

This study estimates the life cycle greenhouse gas (GHG) emissions from the production ofMarcellus shale natural gas and compares its emissions with national average US naturalgas emissions produced in the year 2008, prior to any significant Marcellus shaledevelopment. We estimate that the development and completion of a typical Marcellusshale well results in roughly 5500 t of carbon dioxide equivalent emissions or about 1.8 g CO2e/MJ of gas produced, assuming conservative estimates of the production lifetime of a typical well.This represents an 11% increase in GHG emissions relative to average domestic gas (excludingcombustion) and a 3% increase relative to the life cycle emissions when combustion is included.The life cycle GHG emissions of Marcellus shale natural gas are estimated to be 63–75 g CO2e/MJ of gas produced withan average of 68 g CO2e/MJ of gas produced. Marcellus shale natural gas GHG emissions are comparable tothose of imported liquefied natural gas. Natural gas from the Marcellus shale hasgenerally lower life cycle GHG emissions than coal for production of electricity inthe absence of any effective carbon capture and storage processes, by 20–50%depending upon plant efficiencies and natural gas emissions variability. There issignificant uncertainty in our Marcellus shale GHG emission estimates due to eventualproduction volumes and variability in flaring, construction and transportation.

A life-cycle assessment (LCA) of corn ethanol was conducted to determine the reduction in the life-cycle greenhouse gas (GHG) emissions of corn ethanol compared to gasoline by integrating biomass fuels in a 190 million liter (50 million gallon) per year dry-grind corn ethanol plant to replace fossil fuels (natural gas and grid electricity). The biomass fuels studied are corn stover and ethanol co-products [dried distillers grains with solubles (DDGS), and syrup (solubles portion of DDGS)]. The biomass conversion technologies/systems considered are process heat (PH) only systems, combined heat and power (CHP) systems, and biomass integrated gasification combined cycle (BIGCC) systems. The key inventory components of the LCA are corn production, stover production, ethanol production, fertilizer inputs, truck transport, co-product credits, ethanol transport to blending, biomass fuel conversion systems, and combustion of anhydrous ethanol (E100). The life-cycle GHG emission reduction for corn ethanol compared to gasoline (97.7 g CO2e/MJ gasoline) is 42.5% for PH with natural gas, 61.3% for PH with corn stover, 82.2% for CHP with corn stover, 81.6% for IGCC with natural gas, 127.7% for BIGCC with corn stover, and 119.1% for BIGCC with syrup and stover. These GHG emission estimates do not include indirect land use change effects. GHG emission reductions for CHP, IGCC, and BIGCC include power sent to the grid which replaces electricity from coal. BIGCC results in greater reductions in GHG emissions than IGCC with natural gas because biomass is substituted for fossil fuels. In addition, underground sequestration of CO2 gas from the ethanol plant’s fermentation tank could further reduce the life-cycle GHG emission of corn ethanol by 31.5% compared to gasoline.

Assessing the effectiveness of building retrofits in reducing GHG emissions: A Canadian school case study

We suggest a 2D-plot representation combined with life cycle greenhouse gas (GHG) emissions and life cycle cost for various energy conversion technologies. In general, life cycle assessment (LCA) not only analyzes at the use phase of a specific technology, but also covers widely related processes of before and after its use. We use life cycle GHG emissions and life cycle cost (LCC) to compare the energy conversion process for eight resources such as coal, natural gas, nuclear power, hydro power, geothermal power, wind power, solar thermal power, and solar photovoltaic (PV) power based on the reported LCA and LCC data. Among the eight sources, solar PV and nuclear power exhibit the highest and the lowest LCCs, respectively. On the other hand, coal and wind power locate the highest and the lowest life cycle GHG emissions. In addition, we used the 2D plot to show the life cycle performance of GHG emissions and LCCs simultaneously and realized a correlation that life cycle GHG emission is largely inversely proportional to the corresponding LCCs. It means that an expensive energy source with high LCC tends to have low life cycle GHG emissions, or is environmental friendly. For future study, we will measure the technological maturity of the energy sources to determine the direction of the specific technology development based on the 2D plot of LCCs versus life cycle GHG emissions.

In this paper, we used the life-cycle analysis (LCA) method to evaluate the energy consumption and greenhouse gas (GHG) emissions of natural gas (NG) distributed generation (DG) projects in China. We took the China Resources Snow Breweries (CRSB) NG DG project in Sichuan province of China as a base scenario and compared its life cycle energy consumption and GHG emissions performance against five further scenarios. We found the CRSB DG project (all energy input is NG) can reduce GHG emissions by 22%, but increase energy consumption by 12% relative to the scenario, using coal combined with grid electricity as an energy input. The LCA also indicated that the CRSB project can save 24% of energy and reduce GHG emissions by 48% relative to the all-coal scenario. The studied NG-based DG project presents major GHG emissions reduction advantages over the traditional centralized energy system. Moreover, this reduction of energy consumption and GHG emissions can be expanded if the extra electricity from the DG project can be supplied to the public grid. The action of combining renewable energy into the NG DG system can also strengthen the dual merit of energy conservation and GHG emissions reduction. The marginal CO2 abatement cost of the studied project is about 51 USD/ton CO2 equivalent, which is relatively low. Policymakers are recommended to support NG DG technology development and application in China and globally to boost NG utilization and control GHG emissions.

A probabilistic fleet analysis for energy consumption, life cycle cost and greenhouse gas emissions modelling of bus technologies

In this work, we analysed correlations between life cycle greenhouse gas (GHG) emissions and life cycle cost of energy resources. Energy resources studied in this paper include coal, natural gas, nuclear power, hydropower, geothermal energy, wind power, solar thermal energy, and solar photovoltaic energy, and all of them are used to generate electricity. We calculated the mean values, ranges of maximum minus minimum values, and ranges of 90% confidence interval of life cycle GHG emissions and life cycle cost of each energy resource. Based on the values, we plotted them in two dimensional graphs to analyse a relationship and characteristics between GHG emissions and cost. Besides, to analyse the technical maturity, the GHG emissions and the range of minimum and maximum values were compared to each other. For the electric generation, energy resources are largely inverse proportional to the GHG emission and the corresponding cost.

Introducing demand to supply ratio as a new metric for understanding life cycle greenhouse gas (GHG) emissions from rainwater harvesting systems

Plug-in hybrid electric vehicle (PHEV) technology has the potential to reduce operating cost, greenhouse gas (GHG) emissions, and petroleum consumption in the transportation sector. However, the net effects of PHEVs depend critically on vehicle design, battery technology, and charging frequency. To examine these implications, we develop an optimization model integrating vehicle physics simulation, battery degradation data, and U.S. driving data. The model identifies optimal vehicle designs and allocation of vehicles to drivers for minimum net life cycle cost, GHG emissions, and petroleum consumption under a range of scenarios. We compare conventional and hybrid electric vehicles (HEVs) to PHEVs with equivalent size and performance (similar to a Toyota Prius) under urban driving conditions. We find that while PHEVs with large battery packs minimize petroleum consumption, a mix of PHEVs with packs sized for ∼25–50 miles of electric travel under the average U.S. grid mix (or ∼35–60 miles under decarbonized grid scenarios) produces the greatest reduction in life cycle GHG emissions. Life cycle cost and GHG emissions are minimized using high battery swing and replacing batteries as needed, rather than designing underutilized capacity into the vehicle with corresponding production, weight, and cost implications. At 2008 average U.S. energy prices, Li-ion battery pack costs must fall below $590/kW h at a 5% discount rate or below $410/kW h at a 10% rate for PHEVs to be cost competitive with HEVs. Carbon allowance prices offer little leverage for improving cost competitiveness of PHEVs. PHEV life cycle costs must fall to within a few percent of HEVs in order to offer a cost-effective approach to GHG reduction.

The life cycle Greenhouse Gas (GHG) emissions associated with the production and use of transportation fuels from conventional and unconventional fossil fuel sources in Canada and the USA are investigated. The studied pathways include reformulated gasoline and low sulphur diesel produced from oil sands, oil shale, coal and natural gas, as well as reference pathways from conventional crude oil. comparison of Life Cycle Assessments (LCAs) completed for these fuels indicates considerable uncertainty in these emissions, illustrating the need for further LCAs with particular attention to completeness and transparency. Based on the considered studies, only one unconventional pathway has better GHG emissions performance than the conventional pathways: Fischer-Tropsch diesel from natural gas. However, the limitations of the data used here and other factors that may restrict a switch to natural gas must be considered. Furthermore, there are considerable opportunities to reduce emissions from the unconventional pathways. There is significant potential to produce liquid transportation fuels from unconventional Canadian and US fossil sources. However, to avoid significant increases in GHG emissions, the life cycle GHG implications of almost all pathways will need to be reduced to respond to upcoming regulatory initiatives and to move towards a more sustainable transportation sector.