Abstract
AFM nanoindentation was investigated as a method for determining the micromechanical properties of polymer materials. It is generally accepted that the shape of the tip of the cantilever undergoes a change in a standard AFM setup. The shape defines the projected contact area, so it is a parameter directly proportional to the elastic modulus; any change in the shape thus affects the accuracy of the results. The method suggested in this paper relies on the introduction of an experimentally determined tip-area function. Values for Young’s modulus were calculated for EPDM samples with different degrees of cure and crystallinity. The degree of crystallinity has a greater impact on the mechanical properties of the material than the degree of cure. Depending on the amplitude of the indentation, the E-moduli determined by AFM are systematically higher. When studying different regions of polymer materials, the values of the E-modulus determined by AFM become identical to those measured by means of DMA on extrapolation of the modulus at zero indentation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.