Abstract
Chicken liver phosphoenolpyruvate carboxykinase (PEPCK) was rapidly inactivated by micromolar concentrations of ferrous sulfate in the presence of ascorbate at pH 7.4. Omitting ascorbate or replacing the Fe2+ with Mn2+ or Mg2+ gives no inactivation. Mn2+, Mg2+, or Co2+ at 100-fold molar excess over Fe2+ offered complete protection from Fe2+/ascorbate-induced inactivation. The substrates PEP and GTP, but not OAA, GDP, or CO2, offered full protection from inactivation. The addition of 5 mM EDTA stopped further inactivation of the enzyme. Thermodynamic studies indicate that the inactive enzyme no longer binds Mn2+ but still had high affinity for GTP indicating that the inactivation process was specific for the metal site. A decrease in cysteine content was observed over time following PEPCK treatment with Fe2+ and ascorbate. The apparent first-order rate constant for free sulfhydryl loss (0.085 +/- 0.005 min-1) is similar to the apparent first-order rate constant for inactivation (0.067 +/- 0.005 min-1). Amino acid composition analysis revealed that cysteic acid was generated upon Fe2+/ascorbate addition to PEPCK. Native chicken liver PEPCK has an Mr of 67 kDa. SDS-PAGE of the inactivated enzyme showed the presence of two new bands at 31.7 and 35.3 kDa indicating that PEPCK was specifically cleaved at a single site. The rate of cleavage was slower than the rate of inactivation and fully inactivated enzyme was only 50% cleaved. The Fe2+/ascorbate-catalyzed inactivation was not solely due to protein cleavage. The protein fragments generated by cleavage were separated by C4 reverse phase HPLC. The cleavage exposed a new N-terminus which was identified to be the 35.3 kDa C-terminal half of PEPCK. Sequencing of the fragments indicated that the site of cleavage was between Asp296 and Ile297. These results indicate that Asp296 is involved in metal chelation. This agrees with previous studies [Hlavaty, J. J., & Nowak, T. (1997) Biochemistry 36, 3389-3403] that suggested that Asp295 and Asp296 are involved in metal binding.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have