Aerosol jet printed 3 omega sensors for thermal conductivity measurement.

Abstract

The 3 omega (3ω) method is a trusted technique for measuring thermal conductivity-a fundamental material property of critical importance in a broad range of applications. However, traditional 3ω sensor processing requires some form of physical vapor deposition, such as metal evaporation or sputtering. These 3ω sensor deposition techniques limit the materials and sample sizes applicable to the 3ω method. This work demonstrates an aerosol jet printing method to directly printsilver 3ω sensors that yield accurate temperature-dependent measurement up to 300°C on materials with thermal conductivity ranging from 1 to 150 W/m K. The interrelationship between printed sensor geometry, sensor thermal stability, and applicability to the 3ω method is examined. Thermal conductivity measurement with 3ω sensors conventionally sintered at 300°C agrees to independent laser flash measurement within 4% from room temperature to 150°C. An unconventional rapid high-temperature sintering method is shown to produce sensors that agree within 3% of the laser flash measurements from room temperature to 300°C. The rapid sintering profiles also reduced the sensor-substrate thermal boundary resistance of the printed sensors by as much as 88%. The direct printing of 3ω sensors creates opportunities for measurement of thermal transport properties in applications previously inapplicable to the 3ω method.