Abstract
Hydrophobic rubber-silica aerogel panels (21.5 × 21.5 × 1.6 cm3) were fabricated from silica and rubber sols and reinforced with several fiber types (recycled tire textile fibers, polyester blanket, silica felt, glass wool). A recycled rubber sol was prepared using peracetic acid and incorporated for the first time in TEOS-based sol-gel chemistry. The composites exhibited good thermal stability up to 400 °C and very low thermal conductivity, in the superinsulation range when using polyester fibers (16.4 ± 1.0 mW·m-1·K-1), and of 20-30 mW·m-1·K-1 for the remaining fibers. They could also endure cyclic compression loads with near full recovery, thus showing very promising properties for insulation of buildings.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.