Abstract
This work is concerned with the design of a leading edge for a flat-plate model used to study laminar and transitional boundary layers. For this study, the flow over the complete boundary-layer model, including leading edge, flat section, and trailing-edge flap, is modeled. The effect of important geometrical features of the leading edge on the resulting pressure distribution, starting from the well-known symmetric modified super ellipse, is investigated. A minimal pressure gradient on the measurement side of the plate is achieved using an asymmetrical configuration of modified super ellipses, with a thickness ratio of 7/24. An aerodynamic shape optimization is performed to obtain a novel leading edge shape that greatly reduces the length of the non-zero pressure gradient region and the adverse pressure gradient region compared to geometries defined by ellipses. Wind tunnel testing is used to validate the numerical solutions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
