Abstract
Thermionic energy conversion, a process that allows direct transformation of thermal to electrical energy, presents a means of efficient electrical power generation as the hot and cold side of the corresponding heat engine are separated by a vacuum gap. Conversion efficiencies approaching those of the Carnot cycle are possible if material parameters of the active elements at the converter, i.e. electron emitter or cathode and collector or anode, are optimized for operation in the desired temperature range. These parameters can be defined through the law of Richardson-Dushman that quantifies the ability of a material to release an electron current at a certain temperature as a function of the emission barrier or work function and the emission or Richardson constant. Engineering materials to defined parameter values presents the key challenge in constructing practical thermionic converters. The elevated temperature regime of operation presents a constraint that eliminates most semiconductors and identifies diamond, a wide band-gap semiconductor, as a suitable thermionic material through its unique material properties. For its surface a configuration can be established, the negative electron affinity (NEA), that shifts the vacuum level below the conduction band minimum eliminating the surface barrier for electron emission. In addition, its ability to accept impurities as donor states allows materials engineering to control the work function and the emission constant. Single crystal diamond electrodes with nitrogen levels at 1.7 eV and phosphorus levels at 0.6 eV were prepared by plasma enhanced chemical vapor deposition where the work function was controlled from 2.88 eV to 0.67 eV, one of the lowest thermionic work functions reported. This work function range was achieved through control of the doping concentration where a relation to the amount of band bending emerged. Upward band bending that contributed to the work function was attributed to surface states where lower doped homoepitaxial films exhibited a surface state density of ~3x1011 cm-2. With these optimized doped diamond electrodes highly efficient thermionic converters are feasible with a Schottky barrier at the diamond collector contact mitigated through operation at elevated temperatures.
Highlights
In 2014 the estimated energy consumption in the United States was about 100 Exajoules (Fichman, 2015)
The electron emission current was recorded as a function of diamond sample temperature with the results shown in Figure 6
As the efficiency of a thermionic converter is related to the work function differential between emitter and collector a lower work function collector is preferred with an ideal value of ∼0.5 eV
Summary
In 2014 the estimated energy consumption in the United States was about 100 Exajoules (Fichman, 2015). About 39% of the total U.S energy supply is used to producing electricity with nuclear (8.5%), natural gas (8.5%), and coal (16.7%) the main energy sources (wind 1.7% and hydro 2.5%) while photovoltaics account for 0.17% of the total energy usage. Coal fired power plants operate on a modified Rankine cycle with maximum efficiency of 42%, and gas fired plants slightly lower at 38% similar to nuclear power plant thermal efficiency. Including cars, trucks, buses, trains, ships, and planes, oil is the main energy source and accounts for 28% of the total energy use. Light trucks, and motorcycles consume about 58% of the transportation energy budget signifying the importance of electrical power demands with a shift to electrical propulsion. With a thermionic converter collector work functions of 1 eV an efficiency similar to thermal power plants is indicated and lowering of the collector work function to 0.5 eV would allow an efficiency exceeding 50%
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.