Abstract
The safe operation of both thermal and nuclear power plant is increasingly dependent upon structural integrity assessment of pressure vessels and piping. Furthermore, structural failures most commonly occur at welds so the accurate design and remnant life assessment of welded plant is critical. The residual stress distribution assumed in defect assessments often has a deciding influence on the analysis outcome, and in the absence of accurate and reliable knowledge of the weld residual stresses, the design codes and procedures use assumptions that yield very conservative assessments that can severely limit the economic life of some plant. However, recent advances in both the modeling and measurement of residual stresses in welded structures and components open up the possibility of characterising weld residual stresses in operating plant using state-of–the–art fully validated Finite Element simulations. This paper describes research undertaken to predict residual stresses in stainless steel welds in order to provide validated reliable, accurate Structural Integrity assessment of nuclear power plant components
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have