Advances in on-sea-ice seismic reflection methods using an air gun: McMurdo Sound, Antarctica

Abstract

During the austral spring of 2008, 48 km of multichannel seismic reflection data were collected on a sea-ice platform east of New Harbor, Southern McMurdo Sound, Antarctica. These seismic data were collected to support the Antarctic Geological Drilling Program whose goal is to recover sedimentary rock cores from the continental margin of Antarctica and to better understand the climatic, cryospheric, and tectonic history of Antarctica. A Generator-Injector air gun, deployed through holes drilled in the sea ice, was used for a seismic source, and reflected energy was recorded on a snow streamer consisting of 60 gimbaled geophones. The Offshore New Harbor seismic system has increased the rate of data acquisition by 53% compared to previous Antarctic air-gun/snow-streamer seismic systems. In addition to conventional on-sea-ice seismic data processing, new processing steps were used to correct problems associated with the use of a Generator-Injector air gun in a sea-ice environment. Source timing errors, caused by miscommunications between the Generator-Injector air gun and air-gun controller, were corrected. Newly discovered bubble-plume static errors and bubble-plume wavelet distortions degraded seismic data quality and are attributed to bubble plumes created by the Generator-Injector air-gun blast. Our investigation shows that these bubble plumes were preserved for at least 40 hours beneath the sea ice and created isolated low-velocity zones. Using finite-element methods, we reproduced static errors and wavelet distortions by incorporating the effects of bubble plumes into the finite-element model. The results of finite-element modeling confirmed our hypothesis that bubble-plume static errors and bubble-plume wavelet distortions were caused by near-surface low-velocity features. Therefore, we incorporated new processing steps which remove bubble-plume effects and improve the quality of final seismic sections.