Advanced Signal Processing for Pulse-Amplitude Modulation Optical Transmission Systems

Abstract

Non-coherent optical transmission systems are currently employed in short-reach optical networks (reach shorter than 80 km), like metro networks. The most common implementation in the state-of-the-art is the four wavelength (?) 100 Gbps (4?×25 Gbps) wavelength division multiplexing (WDM) transceiver. In recent years non-coherent optical transmissions are evolving from 100 Gbps to 400 Gbps (4?×100 Gbps). Since in the short-reach market the volume of optical devices being deployed is very large, the cost-per-unit of the devices is very important, and it should be as low as possible. The goal of this thesis is to investigate some general signal processing aspects and, specifically, digital signal processing (DSP) techniques required in non-coherent pulse-amplitude modulation (PAM) optical transmission, and also to investigate novel algorithms which could be applied to this application scenario. In order for a DSP technique to be considered an interesting solution for non-coherent WDM optical networks it has to effectively mitigate at least one of the three main impairments affecting such systems: bandwidth limitations, chromatic dispersion (CD) and noise (in optical or electrical domain). A series of algorithms are proposed and examined in this thesis, and their performance is analyzed by simulation and also experimentally in the laboratory: - Feed-forward equalization (FFE): this is the most common equalizer and it is basically employed in every high-speed non-coherent optical transmission. It can compensate high bandwidth limitations. - Maximum likelihood sequence estimation (MLSE): the MLSE is the optimum detector and thus provides the best performance when it comes to dealing with CD and bandwidth limitations. - Geometrical constellation shaping: in multilevel optical intensity modulation schemes the distance between amplitude levels can be adjusted (such that they are no longer equidistant) in order to increase the signal's tolerance to noise. - Probabilistic shaping: another technique designed specifically for multilevel modulation schemes; it adjusts the probability of each amplitude level such that the tolerance to optical noise is increased. - Partial response signaling (PRS): this is a DSP-based approach where a controlled inter-symbol interference (ISI) is intentionally introduced in such a way that the resulting signal requires less bandwidth. PRS can be customized to also mitigate CD impairment, effectively increasing transmission distances up to three times. - Digital pre-emphasis (DPE): this technique consists in applying the inverse of the transfer function of the system to the signal at the transmitter side which reduces the impact of bandwidth limitations on the signal at the receiver side. - Trellis-coded modulation (TCM): a modulation scheme that combines forward error correction (FEC) elements with set-partitioning techniques and multidimensional modulation to generate a signal that is more resistant to noise. - Multidimensional set-partitioned modulation: very similar with TCM but without any FEC elements. It has lower gains than TCM in terms of noise tolerance but is not so sensitive to ISI. By using the techniques enumerated above, this thesis demonstrates that is possible to achieve 100 Gbps/? optical transmission bitrate employing cost-effective components. Even more, bitrates higher than 200 Gbps are also demonstrated, indicating that non-coherent PAM is a viable cost-effective solution for next-generation 800 Gbps (4?×200 Gbps) WDM transceivers.