Advanced Non-Axisymmetric Endwall Contouring for Axial Compressors by Generating an Aerodynamic Separator—Part II: Experimental and Numerical Cascade Investigation

Abstract

Modern methods for axial compressor design are capable of shaping the blade surfaces in a three dimensional way. Linking these methods with automated optimization techniques provides a major benefit to the design process. The application of non-axisymmetric contoured endwalls is considered to be very successful in turbine rotors and vanes. Concerning axial compressors non-axisymmetric endwalls are still a field of research. This two-part paper presents the recent development of a novel endwall design. A vortex created by a nonaxisymmetric endwall groove acts as an aerodynamic separator, preventing the passage vortex from interacting with the suction side boundary layer. This major impact on the secondary flow results in a significant loss reduction by means of load redistribution, reduction of recirculation areas and suppressed corner separation. Part I of this paper deals with the endwall design and its compressor application. The resulting flow phenomena and physics are described and analysed in detail. The second paper presents the detailed experimental and numerical investigation of the developed endwall groove. The measurements carried out at the transonic cascade wind tunnel of DLR in Cologne, demonstrated a considerable influence on the cascade performance. A loss reduction and redistribution of the cascade loading were achieved at the aerodynamic design point as well as near the stall condition of the cascade. This behaviour is well predicted by the numerical simulation. The combined analysis of experimental and numerical flow patterns allows a detailed interpretation and description of the resulting flow phenomena. In this context high fidelity 3D-RANS flow simulations are required to analyse the complex blade and endwall boundary layer interaction.