Advanced divertor concept design and analysis for HL-2M

Abstract

HL-2M is a tokamak device that is under construction and will be put into operation in the near future. Based on the magnetic coil design of HL-2M, standard divertor, snowflake divertor and tripod divertor configurations have been designed. The potential properties of snowflake divertor configurations have been analyzed, such as the low poloidal field (Bp) area around the X-point, the connection length, target plate and magnetic field shear. The linear peeling-ballooning (P-B) mode is studied by BOUT++ code for snowflake divertor configurations. According to the divertor configuration properties of HL-2M, asymmetric target plates have been concept designed to be compatible with the intended single null (SN) divertor configurations as well as double null (DN) divertor configurations. The SOLPS5.0 code is used to predict the details of the divertor plasma under the conditions of the divertor configurations noted above without impurities. This result shows that the peak heat load on an outer target plate of the advanced divertor is about 40% of that of the standard divertor. But more power will be transported to the inner target plate of advanced divertor, and this will cause a higher peak heat load on the inner target plate. The advanced divertor will also have to work under low plasma recycling conditions with high particle temperature and low density in an open divertor target geometry. When the SN configuration changes to a DN tripod divertor configuration, most of the power exhaust is handled by the outer divertor target plates and the peak heat load on these is about 4.1MW/m2 (with a power exhaust of 20MW). This range of optimized divertor configurations and target geometry will enable the study of advanced divertor physics and high performance plasmas in HL-2M tokamak.