Advanced all-solid-state lithium-selenium batteries enabled by selenium-nitrogen doped hierarchic meso-microporous carbon nanospheres composite cathode

Abstract

Selenium, an element belonging to the same group in the periodic table as sulfur, has a high electronic conductivity (1 × 10−5 S/cm) and a high volumetric energy density (3253 mAh/cm3), which is a prospective cathode material for high-energy all-solid-state rechargeable batteries. However, its wide use is hindered by large volume expansion and low utilization rate. In this work, Se-infused nitrogen-doped hierarchical meso-microporous carbon composites (Se/NHPC) are prepared by a melt-diffusion process. Amorphous Se is uniformly dispersed in meso-micropores of NHPC with a high mass loading of 81%. All-solid-state Li-Se batteries fabricated by using Se/NHPC as the cathode, a Li-In alloy as the anode, and Li6PS5Cl as the solid-state electrolyte, deliver a highly reversible capacity of 621 mAh/g (92% of theoretical capacity), a good rate capability and a high capacity retention value of 80.9% after 100 cycles. It is found that the capacity decay of Se cathode is mainly related to the interfacial degradation and the separation of Se from the carbon substrate, as suggested by the continuous increase of interfacial resistance and the structural transformation from amorphous Sen chains to Se8 rings initial discharge/charge cycle and then to the trigonally crystalline Se chains structure after the long-term cycles.