Abstract
In this study, the adsorption properties of spinel ferrite-based adsorbent, CoFe1.9Mo0.1O4 (CFMo), for removal of methylene blue (MB) from aqueous solution have been investigated. Sol-gel process was successfully employed to prepare CoFe1.9Mo0.1O4 magnetic nanoparticles. The synthesized adsorbent was characterized by Fourier transform infrared (FTIR), scanning electron microscope (SEM) and X-ray diffraction (XRD). The adsorption experiments were carried out at various operational conditions (solution pH, initial dye concentration, contact time, adsorbent dosage and temperature) to evaluate the potential adsorption property of CFMo magnetic nanoparticles. The results showed that, under the optimum adsorption parameters, approximately 95 % of MB dye can be removed. The adsorption data were better described by Langmuir isotherm model and the maximum amount of MB adsorbed was about 20.45 mg/g. Several adsorption kinetic models and thermodynamic parameters (∆Go, ∆Ho, ∆So) were used to fit the adsorption experimental data. The adsorption kinetics followed the pseudo-second-order model (PSO), while the thermodynamic parameters indicate that the proposed adsorption process was endothermic and spontaneous in nature. The obtained results suggest that CFMo is promising adsorbent material for removal of very toxic dyes from aqueous solutions.
Highlights
Synthetic dyes are considered as one of the most dangerous water pollutants because of their detrimental effects on human health and aquatic life [1]
As shown from the X-ray diffraction (XRD) pattern, all diffraction peaks are well indexed to characteristic reflections of magnetite with a cubic structure (JCPDS card No 19-0629)
The obtained results suggest that CFMo is promising adsorbent material for the removal of very toxic cationic dye (MB) from wastewater
Summary
Synthetic dyes are considered as one of the most dangerous water pollutants because of their detrimental effects on human health and aquatic life [1]. The initial pH of dye solution was adjusted to the desired value by adding either 0.1 mol/L HCl or 0.1 mol/L NaOH using a pH-meter (Jenway model 3505, UK).
Sign-in/Register to view highlights & summary Sign-in/Register to access full text options 
Free) 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
