Abstract
Resin adsorption is considered as a promising method to recover gold ions from wastewater, but further reduction reaction is required to convert gold ions into particles. In this study, a crosslinked polyethyleneimine resin (CPEIR) was developed via a suspension polymerization of polyethyleneimine (PEI) and ethylene glycol diglycidyl ether (EGDE) for gold recovery. The Au(III) adsorption capacities of CPEIR were significantly impacted by solution pH and initial Au(III) concentrations but unaffected by co-existing metal ions. Compared with commercial anion-exchange resin IRA400, the CPEIR exhibited higher sorption amount and selectivity for Au(III) due to its high density of amine and hydroxyl groups on the surfaces. The adsorption isotherm of Au(III) on CPEIR was well described by the Langmuir equation, and the maximum uptake amount of Au(III) was high up to 943.5 mg/g, much higher than the reported sorbents. The adsorption kinetic data on the CPEIR were fitted well by the Pseudo-second-order equation, and the intraparticle diffusion was found to be the rate-controlling process of Au(III) adsorption. X-ray photoelectron spectroscopy (XPS) and X-ray diffraction (XRD) analysis confirmed that Au(III) ions were adsorbed on the CPEIR via electrostatic attraction and chelating interaction, and subsequently the partial loaded Au(III) ions were reduced to elemental gold whereas the hydroxyl groups of CPEIR were oxidized to carbonyl groups.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.